PTV Group - Logistics Forum

Hi, I want to know, how xTour creates tours where travelling is possible by ferry only. Lets take Germany, there are dozen islands some accessible by car (via bridge or train), some only by ferry but with cars and some by ferry but without car transport. How does xTour handles these different types?...

Hi, Is there any way to perform some setup to restrict or limit usage of specific roads during the day or particular time of the day while planning a tour? Let me explain my problem, Antwerpen.jpg I have added a map of Antwerp, so you can see the geography. Around Antwerp there is a (partial) ring r...

request / response sent via mail.

Thanks regards,
Prakash

request / response sent via mail.

Thanks regards,
Prakash

Hi, I am using plan basic tour and getting below error: errorKey="10003" message="Could not analyze unscheduled stops (Reason: invalid Stop id). Engine error: Access violation (code: -2) This error is generating while Unscheduled Order Analysis . I checked request and response but got...

Hello Frank,

Yes, you was right it hasn't affected other users.
I did some tests to check point 3 and it worked as I expected, other users has same result as previous after my change.

Best regards,
Prakash

Hello Bernd, Thank you very much. :) All location are drive-able, because with standard param it worked as expected, so i think road network isn't an issue, correct? Your suggestion "cGuidedCMSavings" is also helpful and got my expected result too. But by using cGuidedCMSavings, outcome ha...

Hello, I am also facing similar problem while using balancing param and unable to find the reason of such behavior. While analysis I found "INACCESSIBLE_RELATIONS_USED" and VEHICLE_OPERATING_INTERVAL as unscheduled reason. Please help me to understand in what case/scenario these reason cou...

Thank you for feedback. I followed your suggestion and did changes as below BasicConstructionMethod="cBasicCMInsertion" in combination with TourOpt.INI section [DoBasicTourPlanning.Insertion]: … SeedCriteria.Strategy= Nearest. Results are close to my expectation. But I have few queries: 1)...

Hello, I am using planBasicTours, with several transport orders( having same priority, service period ), 3 vehicles, depot has same start and end Geo location. Given Available machine time is 120. There are several transport order close to depot location, but xTour is planning only two visits per da...