PTV Group - Logistics Forum

The challenge is more to identify whether this is a train or a ferry You can check the type attribute to see if something is a ferry or a piggyback (== api term for rail shuttle). See https://xserver.ptvgroup.com/fileadmin/files/PTV-COMPONENTS/DeveloperZone/Documents/xServer_public/manual/Default.h...

The tunnel restriction code in the waypoint[0].routingoptions does not using the letters enumeration, instead you need to provide the underlying number. See UC_How-to-use-truck-attributes.htm for the translation table (paragraph: Routing with Tunnel Restriction Codes). So in your request you need to...

When i run into this the maps.path in the xlocate.properties is misconfigured or the map in not installed correctly.

About "IDrivingOptions_5_4_0_0::put_ResidentsOnlyFactor" That is found at: Routing / Course / BasicDataRules / SpecialAreas / @residentialMalus (xServer 1 profile) RequestBase.requestProfile.routingProfile.crourse.apecialAreas.residentsOnlyPenalty (xServer 2 request) It is not connected to...

Your axle load is to high. it is set to 11500 and there is a 8000 axle load blocking on the route that goes through the tunnel. Note: although it does not influence this particular route you also have to many axles (5 atm). I would recommend not writing out the entire request profile and just set th...

My mapserver knowledge is a but rusty but IIRC what is mentioned here as extra toll would be the charges for tunnels/birdges/ferries/mountain passes that would be charged apart from regular toll or vingette. After a quick glance I'm not seeing any section in the example given that should contain the...

The truck attributes road editor layer has increased in size over the years. I'm the layer is probably bigger then the 1.18 configuration allows. Try to increase the roadEditorParameter.normLayerSize in the conf/xroute.properties to 80000000 and see if that solves the issue. Note: the 1.18 are outsi...

That works, but keep in mind that it is not an official feature, so in later versions the page might work differently. I don't expect us to make changes in the xServer 1 management console now that we have xServer 2, but it could be.

a route will still be calculated if Course.Violations.Enabled=true is specified in the routing profile This is not correct. When you set prohibitedCountries the engine will no load map data for these countries. In other words: as far as the engine is concerned that country does not exist for the re...

You do actually have to set the directVelocity or else xTour will complain that you are not providing dima information. You can find the parameter on the PlanningParams . Common value we use is 64.