Gurobi: user name mismatch
Posted: Tue May 03, 2022 4:00 pm
Hi,
today I installed a new GUROBI trial on my new laptop. I proceeded as recommended by GUROBI to install the license on my host. Then I started my xServer2 successful but when I tried to calculate a first optimization call I received the following error message:
Well: obviously the license creation process was executed in a command prompt scope within the user "bwe".
But my local xServer v2.25.3 is running as a background service in the uiser context "local system account".
As a temporary solution I decided to run my xServer from the command prompt:
I also found this posts in the Gurobi forum:
https://support.gurobi.com/hc/en-us/com ... ws-Service
https://www.gurobi.com/documentation/9. ... eveLicense
Best regards,
Bernd
today I installed a new GUROBI trial on my new laptop. I proceeded as recommended by GUROBI to install the license on my host. Then I started my xServer2 successful but when I tried to calculate a first optimization call I received the following error message:
Solver problem: User name mismatch (licensed to 'bwe', current user is 'system') - license file'C:\ptv-xserver\server\gurobi.lic'
- gurobi mismatch.png (8.58 KiB) Viewed 5059 times
But my local xServer v2.25.3 is running as a background service in the uiser context "local system account".
As a temporary solution I decided to run my xServer from the command prompt:
- solution: I started the server from the command prompt
https://support.gurobi.com/hc/en-us/com ... ws-Service
https://www.gurobi.com/documentation/9. ... eveLicense
Best regards,
Bernd