Page 1 of 1
xTour: split tour after complete unloading.
Posted: Mon May 29, 2017 2:21 pm
by f.mertens
Hi,
is it possible to change the tour creation handling of "planBasicTours", to start a new tour after the the truck is completely unloaded.
Regards,
Frank Mertens
Re: xTour: split tour after complete unloading.
Posted: Mon May 29, 2017 2:52 pm
by Bernd Welter
Hello Frank,
I'm not sure what the intention behind this special requirement is. I assume, you are dealing with pure AB-orders.
There's no direct approach how to achieve what you describe but maybe you simply want to avoid a specific structure of results? If I'm correct: what is this "no go"-structure?
Best regards
Bernd
Re: xTour: split tour after complete unloading.
Posted: Tue May 30, 2017 9:44 am
by f.mertens
Hello Bernd,
this behavior is requested by our planning department to match the current in-house approach. But at the moment it's not clear, if this is a must-have feature. If it remains necessary, I have to split the result by myself.
Regards,
Frank
Re: xTour: split tour after complete unloading.
Posted: Wed Jun 07, 2017 6:43 am
by Bernd Welter
Hello Frank,
I still didn't get the expectation behind this question?
Can you describe the usecase a bit more in detail?
Best regards
Bernd